7. Increase the temperature of the crankcase halves to
120ºC with a hot air gun.
8. Use a ball bearing removal tool, refer to
access to the crankcase and crankshaft on page 45 ,
to remove the bearings from the crankcase halves.
a) Flywheel side.
1012 - 002 -
b) Clutch side.
To get
7.13.3 To clean and examine the crankcase and
crankshaft
The crankshaft cannot be repaired. Replace it if it is
worn or damaged.
•
Examine the large end of the connecting rod. If there
are marks, discoloration or damaged, replace the
crankshaft.
•
Examine the small end of the connecting rod. If
there are marks or discoloration in the groove of the
bearing, replace the crankshaft.
Repair instructions - 47