Husqvarna 522HD60X Workshop Manual page 30

3. Remove the 2 screws. Remove the air filter holder.
Note: The carburetor is only attached to the fuel
hoses (D) and (E), the transparent hose and the
throttle wire (C).
4. Make a note of the positions of the gaskets (A) and
(B) as they can easily fall off.
E
C
5. Remove the fuel hoses (E) and (D) and the throttle
wire (C).
30 - Repair instructions
B
A
D
6. Remove the 4 screws (F).
7. Remove the diaphragm (G) of the fuel pump and the
valve housing (H).
8. Remove the control diaphragm (I) and check for
damage and wear from the lever arm (L).
9. Remove the gasket (J).
10. Remove the screw (K) and carefully remove the
lever arm (L) and the needle valve (M).
F
G
H
I
J
M
L
K
1012 - 002 -