Weider WESY26331 User Manual page 17

39. Note: The 90mm Pulley (82) used in this step
was attached in step 38. It is shown removed
for easier part identification.
Route the Press Cable (88) around the 90mm
Pulley (82). Make sure that the Cable Trap (80)
is turned to hold the Cable in place and that
the Cable is routed as shown. Tighten the M10
x 120mm Bolt (74) and the M10 Nylon Locknut
(42).
40. Attach the Press Cable (88) to the Front Seat
Frame (8) with an M8 x 69mm Shoulder Bolt (43),
an M8 Washer (20), and an M8 Nylon Locknut
(40). Make sure the flat edge of the Cable is
against the Seat Frame.
41. Identify the High Cable (85)—this is the short-
est remaining cable. Wrap the High Cable
around a 90mm Pulley (82). Attach the Pulley to
the Top Frame (2) with an M10 x 92mm Bolt (76),
an M10 Washer (38), and an M10 Nylon Locknut
(42). Make sure that the end of the Cable with
the ball is on the indicated side of the Pulley
and that the Cable is between the Pulley and
the post.
42. Wrap the High Cable (85) around a 90mm Pulley
(82). Attach the Pulley and a Cable Trap (80) to
the Top Frame (2) with an M10 x 92mm Bolt (76),
an M10 Washer (38), and an M10 Nylon Locknut
(42). Make sure that the Cable Trap is posi-
tioned to hold the Cable in place.
39
74
40
8
40
20
41
2
38
42
Post
85
42
76
2
17
42
9
82
80
88
43
88
Edge
82
76
38
80
82
42
85
Flat