Weider WEBE34100 User Manual page 15

ADJUSTING THE BACKREST
The Backrest (25) can be used in a decline position, a
level position, or either of two incline positions. To
adjust the Backrest to the decline position, remove the
Adjustment Pin (40) and insert it through the top set of
holes in the Backrest Frames (23, 24).
To adjust the Backrest (25) to the level position, insert
the Adjustment Pin (40) through the second set of holes
in the Backrest Frames (23, 24).
To adjust the Backrest (25) to an incline position, insert
the Adjustment Pin (40) through one of the lower two
sets of holes in the Backrest Frames (23, 24).
WARNING:
tion of the Backrest (25), make sure that the
Adjustment Pin (40) is fully inserted through both
Backrest Frames (23, 24) and the holes in the
Bench Frame (26).
ATTACHING WEIGHTS TO THE LEG LEVER
To use the Leg Lever (31), slide the desired amount of
weight onto the Weight Adapter (36).
WARNING:
150 pounds on the Leg Lever (31).
ATTACHING WEIGHTS TO THE WEIGHT CARRIAGE
OR THE BARBELL
To use the high or low pulley station, slide the desired
amount of weight onto the weight tubes of the Weight
Carriage (15) and secure the weights with Weight Clips
(43). To use the Barbell (42, not shown), slide the
desired amount of weight onto each side of the Barbell
and secure both sides with a Weight Clip (43).
WARNING:
150 pounds on the Weight Carriage (15). Always
place the same amount of weight on each side of
the Weight Carriage and on each side of the
Barbell (42, not shown). Always secure the
weights on the Weight Carriage and the Barbell
with the Weight Clips (43).
When adjusting the posi-
Do not place more than
Do not place more than
23
31
36
Weight
Tube
15
15
25
26
40
24
Weight
Tube
43