WEIDER CLUB C670 User Manual page 7

2. Attach a Small Base Cap (20) to the Bench Base
(3) with two M4 x 16mm Screws (36). Attach the
other Small Base Cap in the same manner.
Press the 51mm x 76mm Inner Cap (14) into the
indicated end of the Bench Leg (4).
Attach the Bench Leg (4) to the Bench Base (3)
with four M10 x 71mm Bolts (31), two Bench
Base Joint Plates (25), and four M10 Nylon
Locknuts (34). Do not tighten the Locknuts yet.
3. Attach the Bench Leg (4) to the Bench Frame (1)
with four M10 x 94mm Bolts (98), two Bench Joint
Plates (24), and four M10 Nylon Locknuts (34).
Tighten the M10 Nylon Locknuts (34) used in
steps 1–3.
4. Press two 38mm x 50mm Inner Caps (15) into
the Backrest Frame (6).
Attach the Backrest Bracket (16) to the Backrest
Frame (6) with two M10 x 56mm Bolts (30), two
M10 Washers (35), and two M10 Nylon Locknuts
(34).
5. Attach the Seat Bracket (17) to the Seat Frame
(7) with two M10 x 56mm Bolts (30), two M10
Washers (35), and two M10 Nylon Locknuts (34).
Do not tighten the Locknuts yet.
2
20
31
31
20
3
34
4
4
30
35
15
16
5
35
34
7
14
4
25
25
3
36
24
1
24
98
35
6
34
30
35
7
17
34
34
15