Moving The Bench; Tightening The Cables; Attaching The Curl Pad Or Leg Lever - WEIDER CLUB C670 User Manual

MOVING THE BENCH

To move the weight bench, lift the Bench Leg (4) so
that the bench pivots onto the Wheels (21). Roll the
bench to the desired location and set the Bench Leg
down.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight
rack, can stretch slightly after it is first used. If there is
slack in the cables, tighten them by removing the M10
x 45mm Bolt (33) and the M10 Nylon Locknut (34)
attaching the lower Pulley (87) and Cable Trap (88) to
the two Pulley Plates (82). Reattach the lower Pulley
and Cable Trap to a higher set of holes in the Pulley
Plates using the Bolt and Nylon Locknut.

ATTACHING THE CURL PAD OR LEG LEVER

To use the Curl Pad (9), remove the Adjustment Knob
(22) and the Leg Lever Bracket (18) from the Seat
Frame (7). Slide the Curl Post (8) into the Seat Frame
and secure it in place with the Adjustment Knob.
Attach the Leg Lever (5) in the same manner.
WARNING:
must be positioned in the most inclined posi-
tion before using the Leg Lever (5).
The Seat Frame (7)
34
87
9
5
22
21
4
82
33
88
7
8
22
18