Panasonic DVCPRO HD AJ-HDC27VP Service Manual page 484

2-12. R, G, B W/S Offset
Adjustment (1)
BOARD
-----
TP
SDI OUT 75ohm termination
ADJUST
Service Menu
F NUMBER
-----
MODE -----
CHART Special Light Box (Spherical Type)
M. EQ
Color Monitor TV, WFM
SPEC.
WFM : The waveform is flat at the H
Monitor : No color shading
< Switch Setting >
AUTO W/B BAL
GAIN
OUTPUT
< Menu >
*** CAM MAIN MENU 4 ***
<WHITE SHADING>
Þ CORRECT
*** CAM SERVICE MENU ***
<WHITE SHADING>
Þ DETECTION (DIG)
*** CAM DESIGN MENU ***
<PREPRO 1>
Þ G_WS_OFFSET
Þ B_WS_OFFSET
Þ R_WS_OFFSET
1. Aim at the open portion of light box at about 1/4
size of the whole screen.
2. Execute the ABB.
3. Set the CORRECT of the WHITE SHADING page
to "ON", and execute the DETECTION (DIG).
4. Set the iris to CLOSE and confirm that the
compensation waveform appears on black signal
portion. Adjusts G_WS_OFFSET, B_WS_OFFSET
and R_WS_OFFSET so that the monitor screen
condition has no shading.
5. Set the menu item as follows and turn OFF ® ON
the power of the unit.
*** CAM DESIGN MENU ***
<LSI REG SET1>
Þ ADR_L
Þ ADR_H
Þ WRITE
[ WFM (RGB) : H Rate ]
rate.
: ABB
: L (0 dB)
: CAM ON
: 03
: FF
: OFF ® ON
Compensation
Signal
FLAT
2-13. R, G, B W/S Offset
Adjustment (2)
BOARD
-----
TP
SDI OUT 75ohm termination
ADJUST
Service Menu
F NUMBER
CLOSE
MODE -----
CHART Special Light Box (Spherical Type)
M. EQ
Color Monitor TV, WFM
SPEC.
WFM
Monitor
< Switch Setting >
AUTO W/B BAL
GAIN
AWB
OUTPUT
<Menu >
*** CAM DESIGN MENU ***
<PREPRO 1>
Þ G_WS_OFFSET
Þ B_WS_OFFSET
Þ R_WS_OFFSET
*** CAM DESIGN MENU ***
<LSI REG SET1>
Þ ADR H
Þ ADR L
Þ WRITE
1. Aim at the open portion of light box at about 1/4
size of the whole screen.
2. Set the MASTER GAIN item of the Mid SETTING
page to "6dB".
3. Execute the ABB.
4. Set the CORRECT of the WHITE SHADING page
to "ON", and execute the DETECTION (DIG).
5. Set the iris to CLOSE and confirm that the
compensation waveform appears on black signal
portion. Adjusts G_WS_OFFSET, B_WS_OFFSET
and R_WS_OFFSET so that the monitor screen
condition has no shading.
6. Return the MASTER GAIN of the LOW SETTING
page to original setting.
7. Set the menu item as follows and turn OFF ® ON
the power of the unit.
*** CAM DESIGN MENU ***
<LSI REG SET1>
Þ ADR_L
Þ ADR_H
Þ WRITE
[ WFM (RGB) : H Rate ]
ELE-10
: The waveform is flat at the H
rate.
: No color shading.
: ABB
: M
: A
: CAM ON
: 04
: FF
: OFF ® ON
Compensation
Signal
FLAT