Trigger Switch; Trimmer Head; Operating Instructions - Weed Eater TWIST 'N EDGE 952711895 Instruction Manual

POWER CORD
The POWER CORD is where you attach your
extension cord to the unit.

TRIGGER SWITCH

The TRIGGER SWITCH is used to turn on the
unit. Squeeze the trigger switch to operate the
unit. Release to stop.

OPERATING INSTRUCTIONS

Use only a voltage supply as specified on
your unit.
SELECT AN EXTENSION CORD
Extension Cord Gauge Chart
Length of Cord Gauge
18 Gauge
25 Ft. (7.5 m)
16 Gauge
50 Ft. (15 m)
16 Gauge
100 Ft. (30 m)
Extension cords are available for this unit.
ATTACH THE EXTENSION
CORD TO YOUR TRIMMER
1. Form a loop in your extension cord.
2. Push the loop through the slot in the han-
dle (see illustration).
3. Position the loop over the cord retainer and
pull back to secure.
4. Connect power cord of unit to extension
cord.
LINE LIMITER PIN
The LINE LIMITER PIN cuts the cutting line to
the proper cutting length.

TRIMMER HEAD

The TRIMMER HEAD holds cutting line and
rotates during operation.
CORRECT OPERATING POSITION
Trimming
WARNING:
Always wear eye protec-
tion. Never lean over the trimmer head.
Rocks or debris can ricochet or be thrown into
eyes and face and cause blindness or other
serious injury.
When operating unit, stand as shown and
check for the following:
S Wear eye protection and heavy clothing.
S Hold trigger handle with right hand and as-
sist handle with left hand.
S Keep unit below waist level.
S Cut only from your right to your left to en-
sure debris is thrown away from you. With-
out bending over, keep line near and paral-
lel to the ground and not crowded into
material being cut.
AUTOMATIC LINE FEED SYSTEM
When the trimmer is initially started, a small
length of cutting line is fed out.
After approximately 5 seconds, the line will be
cut to the correct length by the line limiter pin
as the motor reaches full speed. Make sure
the motor is up to full speed before trim-
ming. If the noise of the cutting line being cut
cannot be heard, more line will need to be fed
out.
To feed more line:
S Allow the motor to stop completely; then, re-
start the motor and allow it to reach full
speed.
8
Edging
Line Limiter Pin