Table of Contents
Advertisement
Quick Links
Please do not return product to retailer.
Por favor, no devuelva el producto al lugar de compra.
Veuillez ne pas retourner le produit au détaillant.
1- -800- -554- -6723
Register your product online at:
Registre su producto en línea en:
Enregistrez votre produit en ligne à l'adresse :
www.weedeater.com
Manual de Instrucciones
WARNING:
Read and follow all Safety Rules and Operating Instructions before
using this product. Read instructions carefully before assembling.
Failure to do so can result in serious injury.
ADVERTENCIA:
Lea el manual del operador y siga todas las advertencias e instruc-
ciones de seguridad. Antes de ensamblar el producto lea cuidado-
samente el instructivo. El no hacerlo puede resultar en lesiones gra-
ves.
AVERTISSEMENT:
Veuillez lire le manuel de l'utilisateur et bien respecter tous les
avertissements et toutes les instructions de sécurité. Bien lire les
instructions avant d'assembler l'outil. Tout défaut de le faire pourrait
entraîner des blessures graves.
WEED EATER
7349 Statesville Road
Charlotte, NC 28269
R
Instruction Manual
Manuel d'Instructions
TWIST 'N EDGE
850 Matheson Blvd. West
Mississauga, Ontario L5V 0B4
545186765 Rev. 3 4/15/10 BRW
Trademark
600
R
WEED EATER
Advertisement
Table of Contents
Related Manuals for Weed Eater TWIST 'N EDGE 952711895
Summary of Contents for Weed Eater TWIST 'N EDGE 952711895
- Page 1 Veuillez lire le manuel de l’utilisateur et bien respecter tous les avertissements et toutes les instructions de sécurité. Bien lire les instructions avant d’assembler l’outil. Tout défaut de le faire pourrait entraîner des blessures graves. WEED EATER 7349 Statesville Road Charlotte, NC 28269 545186765 Rev. 3 4/15/10 BRW...
- Page 2 IDENTIFICATION OF SAFETY SYMBOLS DANGER: spool, and 0.065 inch (1.65 mm) recommended trimmer line. Never use blades, flailing devices, wire, rope, string, etc. Unit is designed for line trim- mer use only. Failure to follow these instructions may result in serious injury. WARNING: This unit can be dangerous! Careless or improper use can cause serious injury.
- Page 3 IDENTIFICATION OF SAFETY SYMBOLS This unit is double insulated. All internal service must be completed by an authorized service dealer. Disconnect unit from power source before cleaning or servicing. Do not use with damaged cord. Repair or replace damaged cord immediately. Store unit indoors in a high, dry place out of the reach of children.
-
Page 4: Operator Safety
Never use wire, rope, string, etc. S Use specified trimmer spool. Make sure spool is properly installed and all parts are securely fastened. S Use only WEED EATER replacement parts and accessories as recommended. CUTTING SAFETY WARNING: Inspect area to be cut. -
Page 5: Transporting And Storage
port. Keep firm footing and balance. S Keep the cutting head below waist level. Do not raise handles above your waist. Cutting head can come dangerously close to your body. S Keep away from cutting head and spinning line. S Use unit properly. Use only for trimming, scalping, and mowing. -
Page 6: Wheel Assembly
age to unit (including motor failure) will result. 1. Place the shield onto the motor housing. Ensure the cutting head remains free to rotate and the line is not caught between the shield and the motor housing (see fol- lowing illustration). Motor Housing Line Limiter Cutting Head... -
Page 7: Height Adjustment
1. Turn height adjuster in the direction indi- cated to unlock (see illustration). Height adjuster Unlocked Locked OPERATION KNOW YOUR TRIMMER READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. -
Page 8: Trigger Switch
The POWER CORD is where you attach your extension cord to the unit. TRIGGER SWITCH The TRIGGER SWITCH is used to turn on the unit. Squeeze the trigger switch to operate the unit. Release to stop. OPERATING INSTRUCTIONS Use only a voltage supply as specified on your unit. - Page 9 the line limiter pin (do not repeat this proce- dure more than 6 times). If problems are experienced with the auto- matic line feed, refer to the TROUBLE- SHOOTING TABLE. To manually feed the nylon line: S If required, the cutting line can be fed out manually.
-
Page 10: After Each Use
Edging Edging Direction SCALPING The scalping technique removes unwanted vegetation down to the ground. Hold the bot- tom of the trimmer head about 3 inches (8 cm) above the ground and at an angle. Allow the tip of the line to strike the ground around trees, posts, monuments, etc. -
Page 11: Replacing The Line
4. Clean entire surface of hub and spool. 5. Replace with a pre- -wound spool or cut two lengths of 13 feet (4 meters) of 0.065″ (1.65 mm) diameter WEED EATER brand line. Use of heavier lines could overload and damage unit. - Page 12 spool in line with eyelets (see illustration). Cut out area of spool Eyelet USER REPLACEABLE SERVICE PARTS REPLACEMENT PART Spool with 0.065″ Trimmer Line Spool Cap Assist Handle Wheel STORAGE WARNING: Perform the following steps after each use. S Stop the unit and disconnect the power source when not in use.
- Page 13 WARNING: Always stop unit and disconnect from the power source before performing all of the recommended remedies below except remedies that require unit to be operating. TROUBLE CAUSE Trimmer head 1. Crowding trimmer line stops under a against material being load or does not cut.
-
Page 14: Limited Warranty
WEED EATER brand electric or cordless product within two (2) years from the original date of purchase. If your WEED EATER brand electric or cordless product should fail within the limited warranty period, you may return it in complete condition,...