Maintenance - Intex Giraffe Operation Manual

FUNCTIONAL DESCRIPTION
2. Begin sanding and carefully contact the work surface as lightly as possible-just enough to keep the
sanding head flat against the surface.
Note: Excessive pressure applied to the sanding surface may result in strain and possible
drive shaft breakage. This may void warranty.
3. The joints in the sanding head allow the sanding disc to follow the contours of the work surface.
4. The best technique is to use overlapping sweeps and keep the head in constant motion. Never stop
too long in any one place or there will be swirl marks. With experience it will be very easy to create
excellent results.
Note: Ensure that the Super Pad abrasive you are using is suited to the task. Overly coarse grit paper
may remove material too quickly to control. While overly fine grit paper may clog too often and
not shape down the surface. For more information on grits types visit intex.com.au
Jost
®
®
Super Pads
For excellent finish, we recommend the German made range of Intex Useit
CAUTION: Take care to avoid pointed projections and nails, etc. This will wipe out the sandpaper
and probably damage the sponge pad as well.
MOUNTING THE OPTIONAL BAIL HANDLE
1. Loosen 2 Thumb Screws (05) and remove Clamp Cap (04).
2. Place handle in the desired position on the shaft.
3. Clamp handle in place by replacing the Clamp Cap and tightening
the Thumb Screws.

MAINTENANCE

Every 50 hours of operation blow compressed air through the motor while running at no
load to clean out accumulated dust. (If operating in especially dusty conditions,
perform this operation more often).
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with
a soft damp cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise
damage the material. Wear safety glasses while using compressed air. Clean the vacuum swivel
connector as too much dust will keep it from turning freely.
THE CARBON BRUSHES
The Carbon Brushes are a normal wearing part and must be replaced when they reach their wear limit.
The Intex Power Sanders are fitted with an auto-stop Carbon Brush, this mechanism will stop the Motor
when the brush reaches its wear limit, preventing damage to the Armature.
NOTE: Checking and replacing the carbon brushes should be entrusted to a Authorised Service
Center.
10
Intex Giraffe
®
Dust Extractors
intexinternational.com
®
Super Pads.
®
01
02
02
03
04
05