Maintenance; Service And Adjustments; After Each Use - Weed Eater 545186761 Instruction Manual

Scalping
MOWING
Your trimmer is ideal for mowing in places
conventional lawn mowers cannot reach. In
the mowing position, keep the line parallel to
the ground. Avoid pressing the head into the
ground as this can scalp the ground and dam-
age the tool.
Mowing
WARNING:
Disconnect
source before performing maintenance.
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover items
that have been subjected to operator abuse
or negligence. To receive full value from the
warranty, the operator must maintain unit as
instructed in this manual. Various adjust-
ments will need to be made periodically to
properly maintain your unit.
BEFORE EACH USE
CHECK FOR LOOSE
FASTENERS AND PARTS
S Housing Screws
S Locking Sleeve Assembly
S Assist Handle
S Debris Shield
S Edge Guide

SERVICE AND ADJUSTMENTS

REPLACING THE LINE
Pre- -wound spools offer the most convenient
method for replacing line and ensuring opti-
mum performance.
S Replacement spools are color- -coded to
ensure use of the correct spool with your
unit. Be sure to use the same color spool as
the existing spool.
NOTE:
Always clear dirt and debris from cut-
ting head components when performing any
type of maintenance.
S Hold spool and unscrew cap by turning in
the direction shown on top of the cap.
SWEEPING
The fanning action of the rotating line can be
used for a quick and easy clean up. Keep the
line parallel to and above the surfaces being
swept and move the tool from side to side.
Sweeping

MAINTENANCE

CHECK FOR DAMAGED OR
power WORN PARTS
Contact an authorized service dealer for re-
placement of damaged or worn
S Trigger Switch - - Ensure switch functions
properly by pressing and releasing the trig-
ger switch. Make sure motor stops.
S Debris Shield - - Discontinue use of unit if
debris shield is damaged.

AFTER EACH USE

INSPECT AND CLEAN UNIT AND DE-
CALS
S After each use, inspect complete unit for
loose or damaged parts. Clean the unit us-
ing a damp cloth with a mild detergent.
S Wipe off unit with a clean dry cloth.
S Remove line guide ring and spool.
Cap
Use a pre- -wound spool or refill spool with
line. If using a pre- -wound spool, remove tape
strip from line and spool.
7
parts.
Line guide ring
Spool