Stihl FR 131 T Instruction Manual page 6

English
Transporting the machine
Turn off the engine before transporting
the unit over distances of more than
about 50 meters.
Carry the unit in the normal working
position: Power tool on your back, left
hand on the loop handle and the right
hand on the control handle – even if you
are left-handed – cutting attachment
lowered close to ground.
To reduce the risk of cut injuries, fit
transport guard on the cutting
attachment, even when carrying the tool
for short distances – see also
"Transporting the Unit".
Avoid touching hot parts
of the machine and gear -
box – risk of burns!
By vehicle: When transporting in a
vehicle, properly secure your machine to
prevent turnover, damage and fuel
spillage.
4
Refueling
Gasoline is highly flam -
mable – keep away from
fire or flame – do not spill
any fuel – no smoking.
Always shut off the engine before
refueling.
Do not fuel a hot engine – fuel may spill
and cause a fire.
Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly and avoid fuel spillage.
Only refuel the machine in a well
ventilated place. If fuel has been spilled,
immediately clean the machine – do not
allow your clothes to be splashed with
fuel. If that happens, change your
clothes at once.
After refueling, close the
fuel cap as tightly as
possible.
This helps reduce the risk of unit
vibrations causing an incorrectly
tightened fuel cap to loosen or come off
and spill quantities of fuel.
Check for leaks. Do not start the engine
if there is a fuel leak – serious or fatal
burns could result!
Before starting
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the User
Manual.
Check the fuel system for leaks,
–
especially the visible parts, e. g.,
fuel cap, hose connections, manual
fuel pump (only in machines with a
manual fuel pump). In case of
leakage and damage, do not start
the engine – risk of fire! Have the
machine serviced by a dealer
before using it
Use only an approved combination
–
of cutting attachment, deflector and
handle. All parts must be
assembled properly and securely
The stop switch must be easy to
–
push
Check the choke lever, throttle
–
trigger and throttle trigger lockout
for smooth action - throttle trigger
must return automatically to idle
position. The choke lever must
spring back from the g and <
positions to the run position F when
the throttle trigger lockout and
throttle trigger are squeezed
Check that the spark plug boot is
–
secure – a loose boot may cause
sparking that could ignite
combustible fumes and cause a fire!
FR 131 T