Manually Lighting The Side Burner - Weber SUMMIT S-670 Owner's Manual

16
LIGHTING THE SIDE BURNER
Failure to open the lid while igniting the side burner, or not
waiting 5 minutes to allow the gas to clear if the side burner
does not light, may result in an explosive flame-up which can
cause serious bodily injury or death.
WARNING: Check hose before each use of barbecue for nicks,
cracking, abrasions or cuts. If the hose is found to be damaged
in any way, do not use the barbecue. Replace using only Weber
authorized replacement hose. Contact the Customer Service
Representative in your area using the contact information on
our web site. Log onto www.weber.com
1) Open the side burner lid.
2) Check that the side burner valve is turned off (Push control knob in and turn
clockwise to ensure that it is in the "OFF" position), turn all burners not being used
to the "OFF" position (push in and turn clockwise).
WARNING: The burner control knobs must be in the OFF
position before turning on the liquid propane cylinder valve.
If they are not in the OFF position, when you turn on the
LP cylinder valve, the "excess gas flow control" feature will
activate, limiting the flow of gas from the LP cylinder. If this
should occur, turn OFF the LP tank valve and burner control
knobs. Start over.
When the "excess gas flow control" feature is activated,
a small amount of gas is still flowing to the burners. After
turning OFF the cylinder and burner control knobs, wait at
least 5 minutes for the gas to clear before attempting to light
the barbecue. Failure to do so may result in an explosive
flame-up, which can cause serious bodily injury or death.

MANUALLY LIGHTING THE SIDE BURNER

Failure to open the lid while igniting the side burner, or not
waiting 5 minutes to allow the gas to clear if the side burner
does not light, may result in an explosive flare-up that can
cause serious bodily injury or death.
1) Open the side burner lid.
2) Check that the side burner valve is turned off (Push control knob in and turn
clockwise to ensure that it is in the "OFF" position), turn all burners not being used
to the "OFF" position (push in and turn clockwise).
WARNING: The burner control knobs must be in the OFF
position before turning on the liquid propane cylinder valve.
If they are not in the OFF position, when you turn on the
LP cylinder valve, the "excess gas flow control" feature will
activate, limiting the flow of gas from the LP cylinder. If this
should occur, turn OFF the LP tank valve and burner control
knobs. Start over.
OPERATING INSTRUCTIONS
DANGER
® .
DANGER
DANGER
®
3) Turn the gas supply valve on.
4) Push down and turn the side burner control valve to "HI".
5) Press the igniter button several times so it clicks each time.
CAUTION: Side burner flame may be difficult to see on a
bright sunny day.
WARNING: If the side burner does not light in five (5)
seconds:
a) Turn off the side burner control valve, main burners
and gas supply at source.
b) Wait 5 minutes to let the gas clear before you try
again, or try lighting with a match (see "Manually
Lighting the Side Burner").
WWW.WEBER.COM
®