Weber Summit S-660 Owner's Manual page 16

16
1) Open the lid.
2) Make sure all burner control knobs are turned off. (Push control knob in and turn
clockwise to ensure that it is in the "OFF" position.)
3) Turn on the gas supply at source.
WARNING: Do not lean over the open barbecue.
4) Ignite each adjacent Sear Station
to "START/HI" until you hear the igniter snap - continue to hold control knob in for
two seconds. This action will spark the igniter, the burner lighting tube and then
main burner.
5) Check that the burner is lit by looking through the cooking grates. You should see
a flame. If burner does not light on first try, push control knob in and turn to OFF.
Repeat lighting procedure a second time.
To ignite the Sear Station ™
Sear Burner Lighting: Ignition by an adjacent ignited Main Burner.
6) Turn -Sear Station ™ burner control knob to the ON position.
7) Verify burner ignition by visual inspection of a flame.
WARNING: If ignition does not occur in 5 seconds, turn
burner control OFF, wait 5 minutes, and repeat steps 6 & 7, or
see Match Lighting instructions.
WARNING: If the burner still does not light, turn the burner
control knob to "OFF" and wait 5 minutes to let the gas clear
before you try again or try to light with a match.
Note: See Maintenance for burner removal and cleaning
procedure.
TO EXTINGUISH
Push in and turn each burner control knob clockwise to "OFF" position. Turn gas supply
off at the source.
OPERATING INSTRUCTIONS
™ main burner. Push the control knob in and turn
burner continue with Step 6.
ARRÊTÉ
OFF
APAGADO
B
B.
OFF
1
4
* The grill illustrated may have slight
differences than the model purchased.
2
EN MARCHE
ON
ENCENDIDO
A
A.
ON
5
7
2
6
3
6
EN MARCHE
ON
ENCENDIDO
WWW.WEBER.COM
®