Function Screens - Eaton ON-LINE Series Manual

Shut down in ECO mode
1. Switch-off screen (selftest is disabled)
COMMAND
HELP
3. Select "LOAD OFF ALONE" and press
Enter, the following screen will appear.
Then press Enter to confirm.
CONFIRM
LOAD OFF ALONE
NO, CANCEL
YES, CONFIRM

3.4 Function screens

Power on the UPS, then press "ESC" or do not press any key within 1 min to
automatically enter the state screen. And Press
1. The state screen (1), which displays
load, input voltage and state information
and so on.
LOAD: 100%
I P VOLT: 220.0V
BAT VOLT: 260V
STATE: BYPASS
Note: the item STATE will display UPS power supply, fault and alarm information by
turns every 1S.
2. Press Enter and the following screen
will appear.
COMMAND SELECT
LOAD OFF ALONE
4. Select "ECO DISABLE" and press
Enter, the system will transfer to line mode
and not enter ECO mode automatically.
CONFIRM
ECO DISABLE
NO, CANCEL
YES, CONFIRM
to obtain the below screens.
2. Press to obtain the below information.
OUTPUT PARAMETER
VOUT: 220.5V
IOUT: 45.5A
FREQ: 60.0Hz
28
ECO DISABLE