Replacing The Touchpad; Procedure - Dell G5 5590 Service Manual

Identifier
Status
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Identifier
Status

Procedure

NOTE: Ensure that the touchpad is aligned with the guides available on the palm-rest assembly, and the gap on either sides of
the touchpad is equal.
1 Slide and place the touchpad into the slot on the palm-rest assembly.
2 Align the screw holes on the touchpad bracket with the screw holes on the palm-rest assembly.
3 Replace the two screws (M2x3) that secure the touchpad bracket to the palm-rest assembly.
4 Replace the two screws (M1.6x2) that secure the touchpad to the palm-rest assembly.
5 Adhere the touchpad cable and slide the touchpad cable into the connector on the system board and close the latch to secure the
cable.
GUID-B55423C5-03BB-46A2-9B5F-B8F3B4C854AB
Released
computer. After working inside your computer, follow the instructions in
GUID-700C711D-0FFC-4104-8D22-DD5341B12396
Released

Replacing the touchpad

www.dell.com/
19
After working inside
Replacing the touchpad 49