Weber Summit 89373 Owner's Manual page 33

PROBLEM
Burners burn with a yellow or orange
flame, in conjunction with the smell
of gas (This is normal for the burner
lighting tube).
Sear Station burner does not light.
General Symptoms:
Burner does not light. -or- Burner has
a small flickering flame
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com ® .
OPERATING THE HANDLE LIGHT
The Weber Grill Out™ Handle Light has a built-in "Tilt Sensor." With the power button (a)
activated, the light will come on when the grill lid is open. The light will turn off when the lid
is closed. For daytime use, deactivate the sensor by pressing power button (a).
PROBLEM
™
Weber Grill Out Handle Are the batteries old?
Light does not light.
Are the batteries installed correctly?
Is the lid in the up position with the power button ON?
Is the Weber Grill Out
Is the Weber Grill Out
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com ® .
ATTENTION: This product has been safety tested and is only certified for use in a specific country. Refer to country
designation located on outer carton.
These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products Co., Customer Service Department for genuine Weber-
Stephen Products Co. replacement part(s) information.
WARNING: Do not attempt to make any repair to gas carrying or gas burning components without contacting Weber-Stephen
Products Co., Customer Service Department. Your actions, if you fail to follow this product Warning, may cause a fire or an
explosion resulting in serious personal injury or death and damage to property.
WWW.WEBER.COM
®
SEAR BURNER TROUBLESHOOTING
CHECK
Inspect Spider/Insect Screens for possible
obstructions. (Blockage of holes.)
Did you ignite the two adjacent main burners
(See Sear Station ™ burner lighting instructions
for safe lighting procedure)
Does Burner light with a match?
Does the igniter work (Do you see a spark
when you repeatedly use the snap igniter?
The excess flow safety device, which is part of
the barbecue to cylinder connection, may have
activated.
HANDLE LIGHT TROUBLESHOOTING
CHECK
™ Handle Light activated?
™ Handle Light positioned correctly on the handle?
Clean Spider/Insect Screens. (See Section "Annual Maintenance")
Verify adjacent main burner ignition by visual inspection of a flame.
WARNING: If ignition does not occur in 5 seconds, turn burner control
OFF, wait 5 minutes to let the gas clear before you try again
If you can light Burner with a match, then check the Crossover
burner. (See Maintenance for burner removal and cleaning procedure.)
Try manually lighting the burner (refer to "Lighting the Rotisserie Burner"). Call
customer service.
To reset the excess flow safety device turn all burner control knobs and the cylinder
valve to "OFF" . Disconnect the regulator from the cylinder. Turn burner control knobs
to "START/HI" . Wait at least 1 minute. Turn burner control knobs to "OFF" . Reconnect
the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting
Instructions" .
Replace batteries.
See assembly illustration.
Light will activate when lid is open.
Press the power button.
Adjust position (See assembly illustration).
33
CURE
® Channel on the sear
CURE
33