Suburban DynaPack S Series Architects And Engineers' Manual page 15

• Install the threaded studs into the grille at 6 locations. See Figure 15.
• Install the grille by passing through the lower section of the wall sleeve and
securing the grille mounting brackets with nuts and washers.
• Apply the 1/8" thick gasket to the inside top edge of the base/drain pan. Install the
corner gaskets into the corner notches of the base/drain pan. Caulk any gaps in the
gaskets between the top panel and the side panels.
If the wall sleeve drain is on the inside of the building, now is the time to construct and
install the drain using 3/4" PVC pipe and fittings. See Figure 11 for suggestions on the
drain routing. Pour water into the drain pan to check for leaks in the piping.
Install the DynaPack unit onto the wall sleeve by lifting the unit 3/4" and placing unit
bottom flange over the wall sleeve drain pan. See Figure 12. A pallet jack is the best tool
to accomplish this. A refrigerator dolly or two wheel dolly can also be used but is not as
effective. Raise the unit and temporary prop up with boards.
• Install a front leveling leg bracket on the front bottom edge of each side using two
#12 x 3/4" drill screws on each bracket. See Figure 13.
• Install two 3/8" nuts on each leveling leg and run them down until the nesting
brackets fits under the leveling leg bracket and installs into the slot on the leveling
leg bracket. See Figure 13.
• Secure the Dynapack unit to the wall sleeve by attaching the bracket assembly on
each side of the Dynapack unit with two #10 x 1.5" drill screws on each side. See
Figure 13.
• Double check the level and pitch of the unit from side to side and front to back.
Readjust the leg leveler screws if necessary. Tighten the leveling leg jam nut.
FIGURE 6
15
FIGURE 7
(continued on next page)
Suburban DynaPack A&E Manual 07/2019 Rev.6