Removing The Auto Cutter Unit; Caution When Replacing Parts - Citizen CLP-521 Technical Manual

2-3-3. Removing the Auto Cutter Unit

Note:
Before starting work, be sure to turn off the power of the printer and disconnect the power
cord from the power source.
Remove the Auto Cutter Unit from the printer by performing reverse procedure to installation
procedure.
In this case, while detaching the Cutter Unit from the printer by removing the fastening screw,
hold the Cutter Unit by hand as it can fall down.

2-3-4. Caution when replacing parts

If the following part is removed from the Cutter Stand Unit, adjustment is required when
assembling.
1 Static Eliminator Sheet
2 Metal parts that regulate the cutter
slit width
Static Eliminator Sheet Sticking Position:
Stick the Static Eliminator Sheet to the position shown below.
[Rear view of the Cutter Stand Unit]
Cutter Stand Plate
Cutter slit
Brush
Cut Guide 2
Plate
Positioning is required.
Refer to Chapter 3 "Adjustments".
Static Eliminator Sheet
2-7
Chapter 2 Installation Procedure
CLP-521, CLP-621 & CLP-631