Suzuki RA410 Manual page 276

11) Remove intake manifold with throttle body from cylinder head,
and then its gasket.
INSTALLATION
Reverse removal procedure for installation noting the followings.
Use new intake manifold gasket.
Tighten bolts and nuts to specified torque.
Tightening Torque
(a): 10 N·m (1.0 kg-m, 7.5 lb-ft)
.
(b): 23 N m (2.3 kg-m, 17.0 lb-ft)
Check to ensure that all removed parts are back in place. Rein-
stall any necessary parts which have not been reinstalled.
Adjust accelerator cable play, referring to Section 6E1.
Refill cooling system, referring to "ENGINE COOLING" section.
Upon completion of installation, turn ignition switch ON but en-
gine OFF and check for fuel leaks.
Finally, start engine and check for engine coolant leaks.
ENGINE MECHANICAL 6A4-17