Table of Contents
Advertisement
Note: The Clear Buffer contains only the dash (minus) character. In order
to scan this command, be sure Code 39 length is set to include
length 1.
Transmit Buffer
There are two methods to transmit the Code 39 buffer.
1. Scan the Transmit Buffer bar code below. Only a start character, a plus (+), and a stop
character.
•
The scanner transmits and clears the buffer.
•
The scanner issues a lo/hi beep.
2. Scan a Code 39 bar code with a leading character other than a space.
•
The scanner issues a hi/lo beep to indicate a good decode and that buffering of the
decode data has occurred.
•
The scanner transmits and clears the buffer.
•
The scanner signals that the buffer was transmitted with a lo/hi beep.
Note: The Transmit Buffer contains only a plus (+) character. In order to
scan this command, be sure Code 39 length is set to include length
1.
Transmit Buffer
Symbologies
7-41
Advertisement
Table of Contents
