Mounting The Bike Handle; Mounting And Removing The Deflector - Stihl FS 235 Instruction Manual

6 Assembling the Trimmer
► Insert and tighten down the screw (3) firmly.
The carrying ring need not be removed again.
6.2

Mounting the Bike Handle

► Shut off the engine.
1
2
a
6
► Take out the screws (1).
► Fit the friction liner (4) together with the lower clamp (6) on
the drive tube (5) at distance of 35 cm (a).
► Place the handlebar (3) in the clamp (4).
► Fit the upper clamp (2) so that the holes are in alignment.
► Insert the screws (1).
► Swing the handlebar (3) up and line it up with the cutting
attachment.
► Tighten down the screws (1) firmly.
0458-507-0121-A
3
► Position the control handle (7) and throttle cable (11) over
► Take out the screw (9).
► Fit the control handle (7) on the handlebar (3), trigger
4
5
► Fit the nut (10).
► Insert and tighten down the screw (9) firmly.
► Position the throttle cable retainer (12) and throttle
► Close the throttle cable retainer (12).
The bike handle need not be removed again.
6.3
6.3.1
► Shut off the engine.
12
9 11
and along the drive tube (5) – do not twist the control
handle (7).
facing the gearbox, and line up the hole in the control
handle (7) with the hole in the handlebar (3).
cable (11) against the drive tube.
Do not kink the throttle cable or lay it in tight radii – make
sure the throttle trigger moves freely.
The retainer (12) snaps into place.

Mounting and Removing the Deflector

Mounting the Deflector
English
7
3
8
10
12
5
15