Table of Contents
Advertisement
Figure 27. Disconnect the LCD cable and the touch module cable — the back side of the LCD panel
Note: When disconnecting the LCD cable, peel off the sticker, open the metal bracket, and then
pull out the connector.
Step 5.
Remove the LCD panel.
Table 11. Screw specifications — removing the LCD panel
Screw
Specifications
label
2
M2.5 × 5 mm, flat-head, nylon-coated
Refer to Table 4 "Part numbers of LCD FRUs" on page 26 to look up the Lenovo part numbers of the
following replacement parts:
Hinge covers
LCD panel
Remove the G-sensor board
Make sure the following FRUs (CRUs) have been removed:
"Remove the LCD panel" on page 40
Step 1.
Disconnect the cable
Figure 28. Remove the G-sensor board
Step 2.
Remove 1 screw
Table 12. Screw specifications — removing the G-sensor
Screw
Specifications
label
2
M2 × 2mm, flat-head, nylon-coated
1
.
b
c
a
2
and then remove the G-sensor board
Color
Torque
Silvery
3.7 — 4.0 kgf * cm
3
.
Color
Torque
Black
1.7 — 2.0 kgf * cm
.
Chapter 4
Removing a FRU or CRU
41
Advertisement
Table of Contents
