Table of Contents
Advertisement
Setup
4. Do not dispose of this battery into household garbage, it should be properly
recycled.
5. Do not charge the battery with other electrical devices.
Check Battery Indicator
If you receive a check battery warning, it indicates
one of the following:
• There is no battery in your Handset. You'll need
to install a battery into your Handset (see Instal-
lation and Charge of Battery in Handset sec-
tion on the previous page.)
• The battery has been installed incorrectly. Please reinstall (see Installation
of Battery in Handset) and/or the diagram in the battery compartment on the
Handset.
Connecting to Phone Line
Plug one end of the telephone line cord into the jack on the back of the Base
Unit. Then plug the other end of this cord into the wall jack.
Checking for Dial Tone
After the battery is charged, press ON on the Handset. The LCD displays PHONE
and shows a call timer, and you will hear a dial tone. If not, see In Case of
Difficulty.
Tone/Pulse selection
Your phone is preset for tone dialing. See Handset Settings for details.
CAUTION: Use only the VTech power supply provided with your telephone.
IMPORTANT:
FOR MAXIMUM PERFORMANCE OF YOUR
CORDLESS TELEPHONE SYSTEM:
1. Choose a central location for your Base
Unit.
2. Install your Base Unit and Extension Hand-
sets away from electronic equipment, such
as personal computers, television sets and
microwave ovens.
3. In locations where there are multiple
cordless telephones, separate the Base
Units as far away as possible.
4. Install your telephone equipment away
from heat sources and sunlight.
5. Avoid excessive moisture, dust or extreme cold.
9
Advertisement
Table of Contents
