Hot Water Function - Rinnai Mirai 24 Installation And User Manual

HOT WATER FUNCTION

To use the hot water function of the boiler follow the operations listed below:
1 - Press the DHW (
 The display shows the following symbol:
- DHW function is activated
2 - Press the arrow buttons to set the desired temperature (2).
 The available temperature range is 35÷60°C.
 To select temperatures higher than 55°C the user must
close all the taps prior to push the buttons on the remote
controller.
When this function is used the display shows the following
3 -
symbols:
- hot water request detected (blinking)
- the burner of the boiler is ON
Hot water is produced instantaneously: with Rinnai boiler you will never remain without hot water as long as
electric power, water and gas are supplied.
Prior to use after installation or if the boiler has not been used for a long time let the hot water flow for a while
before using.
The boiler is provided with a sensor that measures the hot water temperature accurately: thanks to this, the
appliance guarantees high comfort and it is extremely safe for all users.
You can still operate the CH mode while the DHW mode is on. The CH mode is not active as long as hot water
is used and the DHW mode is operating.
Both the CH mode and DHW mode can be active at the same time, but priority is always given to DHW mode.
16
-
(Also mentioned as DHW)
) button on the remote (1).
OPERATION
www.rinnai.it