Installing The Wall Mount - Swann NHD-817 Instruction Manual

Installing the Wall Mount

1.
The wall mount can be mounted onto a flat ver-
tical surface and must be of sufficient strength
to hold your camera.
2.
For wooden surfaces, screw the wall mount
directly to the surface. For masonry surfaces
(brick or concrete) you'll need to use the wall
plugs.
3. Position the wall mount in the location you
want to mount it. Make sure the location is rigid
to prevent vibration.
4.
Using the appropriate screws for the surface
you're mounting to, screw the wall mount into
place (use the top mounting holes first). Make
sure the wall mount is aligned straight, other-
wise the image will appear on an angle.
5.
To gain access to the bottom two mounting
holes without obstruction, use a Phillips head
screwdriver to temporarily remove your dome
camera from the wall mount. Be careful as the
camera cable is connected to your dome camera
via one data and one power cable. Gently discon-
nect both cables (see illustration on page 2).
6.
Screw the two remaining screws to the bottom
mounting holes to fasten into place.
7. Reattach the data and power cable to the rel-
evant connections on your dome camera then
screw the camera back onto the wall mount.
Make sure the rubber seal is sitting flush within
the groove of the camera casing and make sure
all the screws are securely fastened.
8.
You're now ready to use your dome camera.
For instructions on how to use your camera, go
to page 6 - Controlling your Dome Camera.
4