Advertisement
ELECTRONIC SPEED CONT ROLLER
Features
Using the latest SMD-MOS FETs
Short protection and safety of full warranty
Compact size for fits anywhere
Plug in and drive
Specifi c ations
Product Name
Product No.
Voltage range
Internal resistance
Momentary Load (1 sec)
Brief Load (30 sec)
Continuous Load (5 min)
BEC Voltage
BEC Current
Frequency
Reverse
Over Load Protection
Setup Procedure
Re verse
Weight
Dimension
Precaution
Before starting your installation of the electronic speed
controller, read the instruction manual carefully.
Make sure if the suppressor capacitors has been soldered
to the motor.
Install the speed control in a position where easy to access
all connectors and the set-up button.
Find a secure location for speed control due to the speed
control is not water resistance.
Do not arrange the speed controller, power cables, receiver
or receiver aerial too close. It may cause the interference
between any of power system components and receiver
aerial.
If the aerial is too long, cut it down to a length of suitable.
Please also refer the instructions that supplied with your
radio control system.
VELOCI PRO-R
Product no. #8023
Veloci Pro-R
8023
4.8-8.4V
0.0175 ½
0.0175
120A
70A
50A
5V
1A
2 KHz
YES
YES
Digital / Push button
YES
31g
26x25.6x15.6mm
Warning
Do not leave your R/C model unattended when the battery
is connected.
Always make sure the switch is off unless under adjust-
ment.
Never touch to water without any protection. The anti- i -
water protection is strongly recommended.
Never run the motor by connecting a separate battery
when the motor is connected to the speed controller.
Never cut off the original plug, as this invalidates the
guarantee.
Avoid incorrect connections and reverse polarity or it will
cause the unit damaged.
In order to provide a cooling air over the speed controller,
do not wrap it .
Set-up Procedure
1. Leave the throttle stick to neutral.
2. Connect the speed control to the battery.
3. Power the speed control on.
4. Press the set-up button at least 3 seconds.
5. The set-up LED now flashes red/green to confirm that the unit
is in set-up mode.
6. Leave the throttle stick at neutral and press the set-up button
again.
7. The neutral setting is now stored, and the set-up LED lights
green.
8. Move the transmitter stick to full-throttle up and press the
set-up button again.
9. The high speed setting is now stored, and the set-up LED
lights red.
10. Move the transmitter stick to full throttle down and press
set-up button again.
11. The reverse setting is now stored, and the set-up red/green
LED lights simultaneously 3 times.
12. Then the red/green LED lights still.
MOTOR SUPPRESSION
capacitor
14
capacitor
capacitor
capacitor
Advertisement
