Table of Contents
Advertisement
Rigging Multi-Column Arrays (Anya/Anna)
The Anya/Anna Flybar has a built in "pin and tapered slot" feature, allowing users to create multi-
column arrays with the proper spacing and angle between columns. Before rigging multi-column
arrays, verify your configuration in Resolution.
1. Begin with two stacks of up to 4 Anna/Anya modules, both with Flybars already rigged on top.
2. Attach chain motors to the Flybar of the first column as defined by your Resolution model,
then raise the first array slightly, and then remove the caster pallet.
3. Move the second column into place and adjust the height of the flown array as needed to align
the columns. Once the columns are at the same height, align the two columns such that the
tabs of one Flybar engage with the slots of the other Flybar.
4. Slide the columns relative to each other until the two quick release Flybar pins can be engaged
through BOTH Flybars.
5. Tighten the two cam levers on the sides of the Flybar by spinning the handles until the
mechanism begins to grab and then flipping the cam lever closed, similar to the operation of a
bicycle wheel's quick-release hub.
6. Proceed as indicated in "Rigging Modules to Flybar" and "Rigging Modules from Modules"
except with multiple columns simultaneously. Take great care when working within the multi-
column array. Tight spacing and many similar and identical rigging grips create the potential for
human error and potential injury.
21
Advertisement
Table of Contents
