Table of Contents
Advertisement
3
Assembling the Frame
Parts needed for this procedure:
1
Eductor mount
1
Flange locknut (5/16 inch)
1
Back plate assembly
1
Right cradle arm
1
Left cradle arm
2
Bushing
2
Pivot pin
2
Jam nut (3/8 inch)
2
Handle
2
Bolt (3/8 x 1-1/4 inches)
2
Set screw
2
Hairpin
2
Flat washer
Installing the Support Frame to
the Tank
1. Remove the 2 flange locknuts securing the tank-lid stop
to the 2 carriage bolts at the rear strap of the sprayer
tank, and remove the tank-lid stop
Note: Retain the tank-lid stop and flange locknut.
Figure 12
1. Tank-lid stop
2. Flange locknut
2. Align the slots in the eductor mount to the 2 lower
carriage bolts of the rear tank strap as shown in
13.
(Figure
12).
g204770
3. Carriage bolt
Figure
1. Slots (eductor mount)
2. Flange locknut (5/16 inch)
3. Loosely assemble the flange locknut (5/16 inch) onto
the lower carriage bolt
4. Assemble the tank-lid stop and 2 flange locknut that
you removed in step
(Figure
14).
1. Flange locknut (5/16 inch)
2. Carriage bolt
5. Torque the 3 flange locknuts to 1978 to 2542 N∙cm
(175 to 225 in-lb).
9
Figure 13
3. Carriage bolt
(Figure
13).
1
onto the 2 upper carriage bolts
Figure 14
3. Tank-lid stop
4. Eductor mount
g204768
g204769
Advertisement
Table of Contents
