1. 90º barbed fitting (eductor
supply hose)
2. Eductor shutoff valve
4. Secure the barbed fitting to the shutoff valve with a
retainer
(Figure
32).
5. Tighten the flange clamp that secures eductor supply
hose to the eductor by hand.
8
Finishing the Installation
Parts needed for this procedure:
1
Suction lance and hose (optional)
Procedure
Note: The suction lance and hose are optional accessories.
Contact your Authorized Toro Distributor for more
information.
Retain the suction lance and hose for later use. Read and
retain the remaining documentation on using the Chemical
Pre-Mix Kit.
Figure 32
3. Retainer
g205929
18