Midland X-TRA TALK MXT100 Owner's Manual page 5

Model MXT100 Series
Mounting
1. Plug power cable into back of radio marked "13.8V DC." Be sure to
observe polarity markings.
2. Use the mounting bracket as a template for marking the location of
screw holes under the dash. Use a nail or other sharp pointed object to
mark the hole locations.
3. Drill a 1/8" hole for each screw hole in the mounting bracket. Attach the
bracket to the dash with the Phillips head sheet metal screws provided.
4. Attach removable 2-pin plug-in DC cord to polarized DC jack on the rear
of the transceiver.
5. Locate and secure the radio into the mounting bracket, allowing working
space for later power connections.
Installation of Microphone
Insert the RJ11 connector into the front of the MXT100. Once the
microphone is connected, use a small tool to insert the strain relief.
The microphone hanger bracket
The bracket can be attached to the vehicle dash or other convenient
location.
NOTE: Extreme care should be exercised when drilling into the dash to
avoid damage to underdash electronic ignition, cruise control, instrument
and/ or accessory wiring.
Page 5 midlandusa.com