IBM Power System S822 Installing Instructions page 31

3) Use the 65-21+11 sequences until it returns A6Bn500B. This indicates that the LAN Adapter will
be enabled in location Cn, where n= the location code of the "Console adapter location". Use
the 21+11 sequence, if it returns A6Bn500C the settings have been saved successfully.
Table 5. Console settings and functions
Console Setting
E2
D1
Bn
Notes:
1) Use the earlier recorded slot number to determine which Bn function should be selected. For
example, if you are using the I/O adapter in slot C2, you would select console setting B2 to
configure the location of the adapter.
2) The Bn may advance from search order rather then numerically. For example, if the search
order is C4,C3,C1, the Bn numbers may show you the 4 before another lower number. This is
determined by model, and not all models will be affected.
If at any time A60x500D is displayed, function has timed out because the function has been
3)
entered too slow). You have a minute to complete a 65-21-11 sequence. Once you start, keep
cycling through and selecting the required settings with no pauses.
Connect the console by completing the following steps:
8.
a. Monitor the console status. After the status changes to Pending Authorization, the Service Tools
Sign-On window opens.
Note: The Service Tools Sign-On window might open behind the Operations Console window.
Resize or move the Operations Console window to locate the Service Tools Sign-On window.
b. Sign on to the Service Tools application. To sign on to the Service Tools application, enter 11111111
for the user ID and password.
c. IPL and configure the system.
d. If your session does not connect, wait for the power-on process to stop on an attention or IPL
failure system reference code (SRC), such as A6005008 or B2xxxx. If the power-on stops at
A6005008, leave the server in this state and call your IBM service provider for assistance.
Note: You must configure and start an IBM i TCP interface on a second port (T2, T3, T4) before
moving the console. This action ensures that there is an alternative method to access the server.
Use the information in step 3b to reset the PC to its original TCP/IP settings.
Note: The PC IP configuration must be reset before cabling the PC back to the network because the
PC is configured with the gateway IP address.
The PC and server console port (T1) can now be recabled to the network.
Continue with "Completing the server setup" on page 19.
Cabling the server and accessing the IVM:
When you install the Virtual I/O Server (VIOS) in an environment where no Hardware Management
Console (HMC) is present, the VIOS automatically creates a management partition whose interface is the
Integrated Virtualization Manager (IVM).
Function
Enable add-on adapter (OPSCONSOLE ENBEXTLAN)
Disable embedded port (OPSCONSOLE DISINTLAN)
Enable LAN adapter in slot Cn (OPSCONSOLE
ENBLSLOT n)
Note: This requires that the embedded (internal) LAN
flag be off and the external flag be on or you will not see
this series.
Installing the IBM Power System S822 (8284-22A)
17