IBM Power System S822 Installing Instructions page 25

Table of Contents

Advertisement

Table 2. Available console types
Console type
Operating system
ASCII terminal
AIX
Hardware
AIX, IBM i, Linux, or
Management Console
VIOS
(HMC)
Integrated
AIX, IBM i, or Linux
Virtualization
Manager for VIOS
Keyboard, video, and
Linux or VIOS
mouse (KVM)
Cabling the server with an ASCII terminal:
If you are not creating logical partitions, you can use an ASCII terminal to manage a server that is
running the AIX, Linux, or VIOS operating systems. From the ASCII terminal, you can access the
Advanced System Management Interface (ASMI) to complete more installation tasks.
The ASCII terminal is connected to the server through a serial link. The ASCII interface to the ASMI
provides a subset of the web interface functions. The ASCII terminal for the ASMI interface is available
only when the system is in the standby state. It is not available during the initial program load (IPL) or
run time.
Note: If you are using a serial connection to the ASMI terminal, you must use a conversion cable. This
cable (part number 46K5108) is used to convert the ASCII terminal 9-pin Dshell connector to an RJ45
serial port connector on the system. For information about the locations of the connectors on the system,
see Part locations and location codes (http://www.ibm.com/support/knowledgecenter/POWER8/p8ecs/
p8ecs_locations.htm).
To cable an ASCII terminal to the server, complete the following steps:
1. Using a serial cable that is equipped with a null modem, connect the ASCII terminal to the serial port
on the rear of the server.
2. Cable the server.
a. Plug the power cord into the power supply.
b. Plug the system power cords and the power cords for any other attached devices into the
alternating current (ac) power source.
Note: Confirm that the system is in standby mode. The green power status indicator on the front
control panel is flashing, and the dc out indicator lights on the power supplies are flashing. If
none of the indicators are flashing, check the power cord connections. For details, see "Common
system attention LEDs and system reference codes" on page 33.
c. If your system uses a power distribution unit (PDU), complete the following steps:
1) Connect the system power cords from the server and I/O drawers to the PDU with an IEC 320
type receptacle.
2) Attach the PDU input power cord and plug it into the alternating current (ac) power source.
3. Wait for the green light on the control panel to start flashing.
4. Ensure that your ASCII terminal is set to the following general attributes.
Logical partitions
®
, Linux, or VIOS
Yes for VIOS, no for
AIX and Linux
Yes
Yes
Yes
Cable required
Serial cable equipped
with a null modem
Ethernet (or
cross-over cable)
Serial cable
Monitor and USB
cables equipped with
KVM
Installing the IBM Power System S822 (8284-22A)
Cabling setup
instructions
"Cabling the server
with an ASCII
terminal"
"Cabling the server
to the HMC" on page
12
"Cabling the server
and accessing the
IVM" on page 17
"Cabling the server
with keyboard,
video, and mouse"
on page 18
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

8284-22a

Table of Contents