Setup; Basic Connections - Vox E 1 Owner's Manual

Setup

NOTE: You MUST turn off the power of all your equipment before you make con-
nections. If you ignore this warning, you may damage your speaker system or
experience malfunctions!
B C
ASIC ONNECTIONS
1. Use audio cables to connect the ToneLab's OUTPUT L/MONO (9.2) to your
mixer/recorder or guitar amp. (p.13, 14)
NOTE: If you're making connections in mono, use the OUTPUT L/MONO jack.
However to take the fullest advantage of ToneLab's sound, we strongly recommend
that you use stereo connections.
If you are using headphones, plug them into the PHONES jack (5.2).
NOTE: Signal from the OUTPUT jack will still be heard even if headphones are
plugged in.
If you want to use an optical cable to connect ToneLab to a digital mixer or
recorder, connect the cable to the S/P DIF OUT jack (9.4). (p.13)
2. If you connect ToneLab to a mixer or recorder, set the AMP/LINE switch (9.1)
to "LINE." If you connect it to a guitar amp, set the switch to "AMP."
3. Turn the LEVEL knob (9.3) located on the rear of ToneLab all the way toward
the left (as seen from the rear), setting the volume to 0.
4. Connect the included AC/AC power supply to the rear panel AC9V power sup-
ply jack (6.1), and then connect the plug to an AC outlet.
5. Plug your guitar into the INPUT jack (5.1).
6. First, turn down the volume of your amp or mixer so you don't hear crackles or
pops when the power is turned on! Then turn on the STANDBY switch (6.2) to
turn on the power.
7. Adjust the volume by using the controls of your amp or mixer, and ToneLab's
rear panel LEVEL knob (9.3).
Guitar
To a mixer/recorder
or guitar amp
LINE/AMP
OUTPUT
L/MONO R
Headphones
PHONES
To a digital Dedicated foot controller
mixer/recorder
S/P DIF OUT
VOX BUS
To a MIDI sequencer
or computer
~AC9V
Mono jack
ToneLab ToneLab
INPUT
12
AC/AC power To an AC
supply outlet