Troubleshooting; Malfunction Table; Replacing The Bulb In The Oven Ceiling Light - Siemens HC854 83 Series Instruction Manual

Free standing
Table of Contents

Advertisement

Close the oven carriage.
6.

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.

Malfunction table

If a dish does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Problem
The appliance does not work.
:
appears in the display.
‹‹
The oven door cannot be opened.
appears in the display. The
displayed.
The oven does not heat up or the type of
heating selected cannot be set.
The oven does not heat up. A small
square lights up in the temperature dis-
play.
"
"‰
" appears on the display.
Error messages with
"
If an error message with
"
is shown in the display, press the
button. This cancels the error message. You may then have to
Error message
"‹‚‚
"‚‚†

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Remove the glass cover. To do this, press back the metal
2.
tabs with your thumb (Fig. A).
Possible cause
Defective fuse
Power cut
Power cut during self-cleaning.
:
‹‹
H
symbol is
Type of heating not recognised
The oven is in demo mode.
Automatic switch-off has been
activated. The oven stops heating.
Possible cause
A button was pressed for too long
or has jammed.
The temperature in the cooking
compartment is too high.
Do not use the oven again until the panels have been
correctly fitted.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Note/remedy
Look in the fuse box and check that the circuit
breaker is in working order.
Reset the clock.
Reset the clock. Wait until the
You can now open the oven door.
Make the settings again.
Switch off the circuit breaker in the fuse box, then
switch it back on after at least 20 seconds. Within
the next 2 minutes, press and hold the
for 4 seconds until the square disappears from the
display.
Press any button.
reset the time. If the error is shown again, call the after-sales
service.
0
You can take remedial action yourself if the following error
messages are displayed.
Note/remedy
Press all buttons individually. Check that the but-
tons are clean. If the error message remains,
please contact the after-sales service.
The oven door locks. Wait until the cooking com-
partment has cooled down. Clear the error mes-
sage with the
Unscrew the bulb and replace it with one of the same type
3.
(Fig. B).
$
Refit the glass cover. When doing this, insert it on one side
4.
and press firmly on the other side. The glass cover will click
into place.
Remove the tea towel and switch on the circuit breaker.
5.
symbol goes out.
H
h
button.
0
%
button
21

Advertisement

Table of Contents
loading

Table of Contents