Setup Instructions; Installing Batteries - Bunker Hill Security 62447 Owner's Manual & Safety Instructions

Setup Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.

Installing Batteries

CAUTION: Position batteries in
proper polarity and do not install
batteries of different types, charge
levels, or capacities together.
1. Using a screwdriver (not included),
remove the Battery Cover of the
Sensor, and insert one 9V battery (not
included). Replace the Battery Cover.
Installing the Sensor and Receiver
CAUTION: Verify that installation
surface has no hidden utility lines
before drilling or driving screws.
1. Consider the following when
choosing a location for the Sensor:
a. The passive infrared sensor detects
heat. Avoid aiming it towards
areas that produce heat such as
heater vents, windows where the
sun hits, or outdoor spotlights.
b. Mount the Sensor at least three
feet above the ground. If placed
under the garage eaves, be sure
that the Sensor is not blocked
by the roof facia board.
c. If placed above eight feet high,
the Sensor should be aimed
downward so that it is pointed
toward the area being monitored.
Item 62447
For technical questions, please call 1-888-866-5797.
2. Using a screwdriver (not included),
remove the Battery Cover of the
Receiver, and insert three
C batteries (not included).
Replace the Battery Cover.
Note: An optional 6 volt, 200 mA power
adapter (not included) can be used to
power the Receiver instead of batteries.
2. Mount the Sensor to a flat
surface with hardware (3).
3. Place the Receiver within
400 feet of the Sensor.
Note: Obstructions may reduce
the receiving range.
4. Mount the Receiver to a flat surface
with hardware, or stand on a
flat surface. The receiver is not
intended to be weather resistant.
Note: Do not install the receiver in a
location that will get wet or directly
exposed to the elements.
Page 5