Advertisement
Owner's Manual & Safety Instructions
Save This Manual
operating, inspection, maintenance and cleaning procedures. Write the product's serial number in the
back of the manual near the assembly diagram (or month and year of purchase if product has no number).
Keep this manual and the receipt in a safe and dry place for future reference.
Email our technical support at: productsupport@harborfreight.com
When unpacking, make sure that the product is intact
and undamaged. If any parts are missing or broken,
please call 1-888-866-5797 as soon as possible.
©
Copyright
2018 by Harbor Freight Tools
No portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein.
Tools required for assembly and service may not be included.
Keep this manual for the safety warnings and precautions, assembly,
Visit our website at: http://www.harborfreight.com
®
. All rights reserved.
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
18k
64734
Advertisement
Related Manuals for Bunker Hill Security 64734
Summary of Contents for Bunker Hill Security 64734
- Page 1 (or month and year of purchase if product has no number). Keep this manual and the receipt in a safe and dry place for future reference. Visit our website at: http://www.harborfreight.com 64734 Email our technical support at: productsupport@harborfreight.com When unpacking, make sure that the product is intact and undamaged.
-
Page 2: Table Of Contents
8. Use eye protection. Wear ANSI-approved impact safety goggles when setting up this product. Page 2 For technical questions, please call 1-888-866-5797. Item 64734... - Page 3 If there is any doubt, do not set up the Light. 14. Contains Li-Ion battery. Battery must be recycled or disposed of properly. Do not open, crush, heat above 140°F or incinerate. SAVE THESE INSTRUCTIONS. Item 64734 For technical questions, please call 1-888-866-5797. Page 3...
-
Page 4: Specifications
Lamp will slide onto ridge. will occur. Move it up or down using the screw located on the neck of the Motion Detector Head. Page 4 For technical questions, please call 1-888-866-5797. Item 64734... - Page 5 Functions Lamp Battery Housing Solar Power Input Power Switch Motion Detector Head Solar Panel Motion Detector Controls (on bottom of Motion Detector Head) Power Cable Base Item 64734 For technical questions, please call 1-888-866-5797. Page 5...
-
Page 6: Operation
Sensor’s sensitivity to motion (SENS) b. Light duration (TIME) c. Sensitivity to light level (LUX) Underside of Motion Detector Head NOTE: After each adjustment, walk the detection area to verify the adjustment made. Page 6 For technical questions, please call 1-888-866-5797. Item 64734... - Page 7 Note: If the Security Light is not operating at night due to interference from a street light or other interference, turn the LUX knob towards the maximum setting . Adjust the dial as needed between the minimum and maximum settings to achieve the desired level of sensitivity. Item 64734 For technical questions, please call 1-888-866-5797. Page 7...
- Page 8 The light should go on in the area that you set up the Security Light to monitor. Adjust the Knobs and sensor, then re-test until the unit functions as desired. Repeat the test procedure as needed when weather and/or temperature changes. Page 8 For technical questions, please call 1-888-866-5797. Item 64734...
-
Page 9: Maintenance
Do not open, 2. Turn the Lamp off and remove crush, heat above 140°F or incinerate. the screws on the back. 3. Disconnect the battery and remove it from the Lamp. Item 64734 For technical questions, please call 1-888-866-5797. Page 9... - Page 10 Note: If product has no serial number, record month and year of purchase instead. Note: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. Page 10 For technical questions, please call 1-888-866-5797. Item 64734...
-
Page 11: Parts List And Diagram
SENS Adjusting Knob Battery Housing TIME Adjusting Knob Motion Detector Head Battery (not shown) Mounting Plate Solar Power Cable (not shown) Power Switch SENS TIME Underside of Motion Detector Head (6) Item 64734 For technical questions, please call 1-888-866-5797. Page 11... -
Page 12: Warranty
Limited 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.