Specifications; Setup - Bunker Hill Security 64734 Owner's Manual & Safety Instructions

Specifications

Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the
following pages, refer to Parts List and Diagram on page 11.
Installation
1. Decide where to place the Lamp and Solar Panel.
a. The Solar Panel is equipped with a 15 foot long
Solar Power Cable, so the Lamp and Solar
Panel can be installed up to 15 feet apart.
b. The Solar Panel must be set in a location
that receives full, direct sunlight, a minimum
of 8 hours a day. Ideally, the Solar
Panel should be angled slightly toward
the South (northern hemisphere).
2. Mount the Solar Panel:
a. Place the Solar Panel in the desired location,
adjusting the unit to best fit the surface.
WARNING! TO AVOID INJURY FROM ELECTRIC
SHOCK, verify the installation surface has no hidden
utility lines before drilling or driving screws.
b. Using the Solar Panel's base as a template,
mark the hole locations to install the
panel. Set the Solar Panel aside.
c. Drill holes for the enclosed mounting Anchors.
d. Insert the Anchors into the holes and attach
Solar Panel in place with the Screws.
3. Mount the Lamp:
a. Locate the unit 6 to 8 feet above ground on
a solid surface capable of supporting the
Lamp and secure enough so that it will not
move when exposed to vibrations or wind.
The unit must be high enough to allow for
motion detection and light distribution.
WARNING! TO AVOID INJURY FROM ELECTRIC
SHOCK, verify the installation surface has no hidden
utility lines before drilling or driving screws.
b. Using the Mounting Plate as a template,
mark the hole locations to install the Lamp.
c. Mount plate against a wall with ridge pointing
up and out. Lamp will slide onto ridge.
Page 4
Lamp 100 SMD LEDs
Battery Pack 3.7V Li-Ion Battery, 2500 mAh
For technical questions, please call 1-888-866-5797.
Mounting Plate
d. Drill holes for the enclosed Anchors.
e. Insert the Anchors into the holes and attach
Mounting Plate in place with the Screws.
f. Slide Lamp onto the Mounting Plate
and position lights as needed. Each
light moves independently.
Mounting
Plate
4. Carefully route the Power Cable from the Solar
Panel to the Lamp and plug it into the Solar
Power Input on the Lamp's Battery Housing.
5. Adjust the Motion Detector Head by moving it left
or right so that it faces the area where movement
will occur. Move it up or down using the screw
located on the neck of the Motion Detector Head.
Item 64734