Sony Walkman MZ-R900 Operating Instructions Manual page 86

BEditing recorded tracks
You can edit your recordings by adding/
erasing track marks or labeling tracks and
discs.
Premastered MDs cannot be edited.
Notes on editing
• Do not move or jog the recorder while "TOC
Edit"* is flashing in the display.
• You cannot edit tracks on an MD that is
record -protected. Before editing tracks,
close the tab on the side of the MD.
• If you perform an editing operation while
playing, be sure not to turn the power off
until "TOC Edit" disappears in the display.
• The lid does not open until "TOC Edit"
disappears in the display after editing.
* TOC = Table of Contents
Erasing a track
See the illustration in the Japanese text
(page 43).
You can quickly erase a recorded track.
Note that once a recording has been erased,
you cannot retrieve it. Make sure of the
track you are erasing.
1 While playing the track you want to
erase, press the jog lever (L), flip the
lever repeatedly until "EDIT" flashes
in the display, and then press the lever
again.
" : Name" flashes in the display,
and the recorder plays the selected
track repeatedly.
2 Flip the jog lever (L) until "
flashes in the display, and then press
the lever.
"Erase OK?" and "PushENTER"
appear alternately in the display.
To cancel erasing, press x.
Press the jog lever (L) again.
3
The track is erased and the next track
starts to play. All the tracks after the
one erased are automatically
renumbered.
To erase a part of a track
Add track marks at the beginning and the
end of the part you want to erase, then
86
erase the part.
Erasing a whole disc
See the illustration in the Japanese text
(page 44).
You can quickly erase all the tracks and
data of the MD at the same time. Note that
once a recording has been erased, you
cannot retrieve it. Be sure to check the
contents of the disc you want to erase.
1 While the recorder is stopped, press
the jog lever (L), flip the lever until
"EDIT" flashes in the display, and then
press the lever again.
"
Flip the jog lever (L) until "
2
Erase" flashes in the display, and then
press the lever.
"AllErase?" and "PushENTER" appear
alternately in the display.
To cancel erasing, press x.
3 Press the jog lever (L) again.
"TOC Edit" flashes in the display, and
all the tracks will be erased.
When erasing is complete,
"BLANKDISC" appears in the display.
Adding a track mark
See the illustration in the Japanese text
(page 44).
You can insert a track mark into a track.
1 While playing or pausing an MD, press
T MARK on the recorder at the point
: Erase"
you want to mark.
"MARK ON" appears in the display,
and the track mark is added.
To add track marks while
recording (except while synchro-
recording)
Press T MARK at the point you want to add a
track mark. You can use Auto Time Stamp to
add track marks automatically at specified
intervals.
: Name" flashes in the display.
: