Sony Walkman MZ-R900 Operating Instructions Manual page 77

BMD playing
Playing an MD right away!
See the illustrations in the Japanese text
(page 21).
If you want to use the rechargeable battery,
be sure to recharge them before playing
(page 74).
1 Start playing.
1 Press the jog lever (R)(N). Turn
the control towards N> on the
remote control.
A short beep sounds in the
headphones/earphones.
2 Press VOL +/– on the recorder to
adjust the volume. Pull and turn
the control towards VOL + or
towards VOL – on the remote
control.
To stop play, press x.
To
Do this (Beeps in the
headphones/earphones
Find the
Flip the jog lever (R)
beginning of the towards .. Turn the
current track
control towards . on
the remote control.
(Three short beeps)
Find the
Flip the jog lever (R)
beginning of the towards >. Turn the
next track
control towards N>
on the remote control.
(Two short beeps)
Go backwards
Flip and hold the jog
2)
while playing
lever (R) towards
Flip and hold the
control towards .
on the remote control.
Go forward
Flip and hold the jog
1)
while playing lever (R) towards >.
Flip and hold the
control towards
N> on the remote
control.
Press X. (Continuous
Pause
short beeps)
Press X again to resume
play.
Remove the
MD
1) You can turn off the beep sound.
2)
To go backwards or forward quickly
without listening, press X and flip and hold
the jog lever (R) towards . or > (turn
and hold the control on the remote control).
3)
Once you open the lid, the point to start play
will change to the beginning of the first track
(except when the disc information has been
stored in the Personal Disc Memory).
About the anti-skip function
The anti-skip function provides resistance
to vibrations for varying length of time
depending on the playback mode of the
track.
Mode
Stereo
LP2 Stereo
LP4 Stereo
Monaural
1)
)
If the playback does not start
Make sure the recorder is not locked. If it
is locked, slide the HOLD switch in the
opposite direction of the arrow.
When using the headphones/
earphones connect them directly
to the recorder
The VOL +/– buttons and the Digital Sound
Preset function may become inoperative. In
this case, do the procedure below.
1 Press the jog lever (L), flip the lever
..
until "AUDIO OUT" flashes in the
display, and then press the lever again.
2 Flip the jog lever (L) until
"HeadPhone" appears in the display.
3 Press the jog lever (L) again.
Notes
• The sound may skip during playback when
the recorder is exposed to continuous
vibration, such as while jogging.
• If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected)
when the recorder is operating, the lid will
not open until the power is restored.
Press x, then slide
OPEN to open the lid.
Display Vibration
resistance time
(none) Approx. 40 sec.
LP2 Approx. 80 sec.
LP4 Approx. 160 sec.
MONO Approx. 80 sec.
3)
77