Using Optional H - GE 29484 User Manual

NOTE: Only one-way conversation is possible in speakerphone mode. When
you are speaking, you are transmitting. When you are listening, you are
receiving. You can't do both at the same time. The phone will automatically
switch between transmitting and receiving depending on the level of the voice
or the room noise picked up by the speakerphone mic.
U O
SING THE PTIONAL
CAUTION: Use only the ATLINKS USA, Inc. 5-2425 headset with
this unit. Using other headsets may damage the unit. For
information on ordering the headset, refer to the Connecting an
Optional Headset section of this user's guide.
1. Headset jack is located on the left side of the base.
2. When unit is in idle mode, press the HEADSET button. The HEADSET
indicator blinks.
3. Press a line button to speak through the headset. The HEADSET
indicator stays lit.
4. Press the HEADSET button again to drop the call. The headset
indicator blinks.
5. If headset is not used frequently, press HEADSET button again to turn
off the headset mode. The headset indicator turns off.
NOTE: If the headset is not connected, an error tone is heard when the
HEADSET button is pressed.
NOTE: During headset mode, if the headset is unplugged and not reinserted
within 15 seconds, the unit automatically disconnects the line.
R I
ECEIVING NCOMING
U H
SING THE ANDSET
When the phone rings, the corresponding line's indicator flashes rapidly.
1. Pick up the handset. The line is automatically selected.
2. When you are finished, hang up the handset.
12
H
EADSET
C
ALLS