Whirlpool AWM 320 Quick Reference Manual page 14

WATER SUPPLY
• Water supply: only cold water.
• Tap: 3/4" threaded hose connector.
• Water pressure (mains pressure):
2
10-100 N/cm (1-10 bar).
For Great Britain and Ireland only
• Water inlet: hot and cold fill. The warm water inlet
temperature must not exceed 60°C.
INLET HOSE(S)
Note: If the inlet hose is already fitted to the rear panel
on the appliance, ignore points 1 and 4.
1. Remove the inlet hose from the drum.
2. Fit the mesh filter supplied in the thread between
the straight end of the inlet hose(s) and the tap(s).
3. Carefully screw the straight end of the inlet hose(s)
to the tap(s) by hand.
4. Screw the curved end of the hose to the appliance
taking care that the hose is not kinked.
5. Turn the tap(s) on fully and check that the joints at
the washing machine and the tap(s) are watertight.
• If the hose is not long enough, replace it with a
suitable length of pressure-resistant hose
(approved under EN 500 65 to withstand a
minimum of 10 bar).
• Check the hose regularly for brittleness and cracks
and replace if necessary.
• The washing machine may be connected without a
non-return valve.
• Observe any special local regulations regarding
connection to the water supply.
16
INSTALLATION INSTRUCTIONS