Vivotek Network Camera IP7133/IP7134 User Manual page 24

VIVOTEK - A Leading Provider of Multimedia Communication Solutions
PPPoE (Point-to-point over Ethernet)
Select this option to configure your Network Camera to make it accessible from anywhere as
long as there is an Internet connection. Note that to utilize this feature, it requires an account
provided by your ISP.
Follow the steps below to acquire your Network Camera's public IP address.
1. Set up the Network Camera in LAN.
2. Go to Configuration > Application > Server Settings (please refer to Server Settings on page 45) to
add a new server -- email or FTP server.
3. Go to Configuration > Application > Media Settings (please refer to Media Settings on page 43). Select
System log so that you will receive a list of system log in TXT file format which contains the Network
Camera's public IP address in your email or on the FTP server.
4. Go to Configuration > Network > Network Type. Select PPPoE and enter the user name and password
provided by your ISP. Click Save to take effect.
5. The Network Camera starts to reboot.
6. Disconnect the power source of the Network Camera; remove it from the LAN environment to the
Internet.
NOTE
► If the default ports are already used by other device connecting to the same router,
the Network Camera will select other ports for the Network Camera.
TM
► If UPnP is not supported by your router, you will see the following message.
► Steps to enable UPnP
Note that you must log on to the computer as a system administrator to install the UPnP
components.
1. Go to Start, click Control Panel, and then click Add or Remove Programs.
24 - User's Manual
TM
user interface on your computer:
TM