Advertisement
Advertisement
Table of Contents
Related Manuals for Jacuzzi J-SS40 Salt System
Summary of Contents for Jacuzzi J-SS40 Salt System
- Page 1 Jacuzzi ® J-SS40 Salt System Installation and Operating Instructions...
-
Page 2: Important Safety Instructions
GENERAL OVERVIEW Your Jacuzzi® J-SS40 Salt System works by converting some of the salt (sodium chloride) in your pool into chlorine which starts to destroy algae and bacteria and sanitises your pool. As part of the process, the chlorine is converted back into salt and hence salt is not consumed. -
Page 3: Cell Installation
INSTALLATION The Jacuzzi® J-SS40 Salt System control has a Rating of IP23 enabling it to be installed outdoors. Regulations require that the control is not allowed to be located within 10 feet of the pool water. The Jacuzzi® J-SS40 Salt System Control should be installed in a well ventilated position ideally away from direct sunlight. -
Page 4: Pool Preparation
POOL PREPARATION The recommended salt level for the Jacuzzi® J-SS40 Salt System is 4,000ppm. The Salt System requires between 3000ppm and 4000 ppm of salt dissolved into the pool water. The level of salt will depend on water temperature, but if a level of 4000 ppm dissolved salt is allowed for, your Salt System will always be able to produce the maximum level of chlorine. -
Page 5: Total Alkalinity
A typical pool of around 13,000 gallons requires 600 Ibs of salt to initially set-up the pool to 5,000ppm. A low salt level warning is indicated on your Jacuzzi®J-SS40 Salt System if the salt level drops. If Low Salt is indicated, check again in 24 hours and then if it is still indicated, add two 50 lb bags of salt to the shallow end of your pool. -
Page 6: Cell Maintenance
Jacuzzi® J-SS40 Salt System Cells have a negative charge sensor that monitors the flow and salt levels of the water. This sensor is designed to be fail safe. As it is negative charge deposits of calcium or other debris may be deposited on it and cause it to indicate a low salt or no flow condition. - Page 7 If unable to perform the maintenance yourself, contact www.Jacuzzipool.com who will arrange a trained service technician to perform the maintenance for you. Record your Equipment details here for quick reference: Model No.: ____________________________ Serial No.: ____________________________ Inst date.: ____________________________ Installer.: ____________________________ INST 397 Jacuzzi® J-SS40 Salt System V05-16...
-
Page 8: Troubleshooting
TROUBLESHOOTING Your Jacuzzi® J-SS40 Salt System has diagnostic and safety features to make it easy to maintain your system. The table below summarises potential faults and their causes. Fault Indication Potential Cause Remedy No Flow Pump turned off/disconnected or valves...