Web; Viewing System Log; Viewing System Parameters; Restore Factory Default Settings - Vivotek NetworKam IP2111 User Manual

Web

Viewing system log

Click the button on the configuration page to view the system log file. The content of the file reveals
useful information about configuration and connection after the system boots up.

Viewing system parameters

Click the button on the configuration page to quickly view the whole system parameter set. The content is
the same as CONFIG.INI.

Restore factory default settings

Click the button on the configuration page to restore the factory default settings. This means any changes
made before will be lost and the system will be reset to the initial status as shipping out of the factory.
After confirmation, the system will restart and require the installer program to setup the network.

Clear data path for proprietary commands

NetworKam provides a highly customized control support to third-party serial interface devices aside
from PTZ cameras. That means in addition to setting up a custom camera with PTZF commands, users
may utilize this mode and introduce a customized homepage to transmit arbitrary user-defined commands
from user-side to NetworKam. The third-party device connected to the serial port of NetworKam will
receive the same command sent by the originator. The user only needs to attach the command in ASCII
format after the special URL. NetworKam will parse the commands and transfer into binary code to send
out. See the clear data mode serial port driver in the URL commands of NetworKam section for detailed
description.
70
www.vivotek.com
T: 886-2-22404099
F: 886-2-22404097