General Procedure; Unpacking The Device - Siemens RUGGEDCOM RX1501 Installation Manual

Installing the Device
2.1 General Procedure
This product should be installed in a restricted access location where access can only
be gained by authorized personnel who have been informed of the restrictions and
any precautions that must be taken. Access must only be possible through the use of
a tool, lock and key, or other means of security, and controlled by the authority re-
sponsible for the location.
2.1

General Procedure

The general procedure for installing the device is as follows:
IMPORTANT
The user is responsible for the operating environment of the device, including main-
taining the integrity of all protective conductor connections and checking equip-
ment ratings. Make sure to review all operating and installation instructions before
commissioning or performing maintenance on the device.
1.
2.
3.
4.
5.
6.
7.
2.2

Unpacking the Device

When unpacking the device, do the following:
1.
2.
3.
If any item is missing or damaged, contact Siemens for assistance.
6
Review the relevant certification information for any regulatory requirements.
For more information, refer to
Review the RUGGEDCOM RX1500 Series Modules Catalog for special installation
or regulatory requirements related to the modules installed in the device. In the
case of cellular modem line modules, this includes antenna installation and reg-
ulatory requirements.
Mount the device.
Connect the failsafe alarm relay.
Connect power to the device and ground the device to safety Earth.
Connect the device to the network.
Configure the device.
Inspect the package for damage before opening it.
Visually inspect each item in the package for any physical damage.
Verify all items are included.
NOTICE
"Approvals (Page 51)".
Installation Manual, 05/2020, C79000-G8976-1054-17
RUGGEDCOM RX1501