Commissioning Sitrans Tf With 4; Commissioning Sitrans Tf With Hart - Siemens SITRANS T Series Compact Operating Instructions

Commissioning

6.6 Commissioning SITRANS TF with HART

6.5 Commissioning SITRANS TF with 4 ... 20 mA
Condition
Before you start, note the following safety notes:
• General safety notes (Page 19)
• Basic safety notes: Installing/mounting (Page 23)
• Basic safety notes: Connecting (Page 37)
• Basic safety notes: Commissioning (Page 61)
Read the entire device manual in order to achieve the optimum performance of the device.
Procedure
1. Mount the device.
Mounting the SITRANS TF single chamber housing (Page 31)
Mounting the SITRANS TF dual chamber housing (Page 32)
2. Connect the device.
Connecting the SITRANS TF single chamber housing (Page 47)
Connecting the SITRANS TF dual chamber housing (Page 54)
3. For devices with intrinsically safe protection type, use an isolating power supply that
corresponds to the requirements of the relevant type of protection.
4. Switch on the power supply.
Switching on the supply voltage (Page 61)
5. Wait for 2 seconds.
After this startup time, the device is operational.
6. Wait 5 minutes to get exact measured values.
7. If you want to change the factory settings, configure the device using the keys or the USB
modem and the SIPROM T parameter assignment software.
– Read the operating instructions for information on this.
8. Lock the device.
– Read the operating instructions for information on this.
6.6 Commissioning SITRANS TF with HART
Condition
Before you start, note the following safety notes:
• General safety notes (Page 19)
• Basic safety notes: Installing/mounting (Page 23)
64
SITRANS TH320/TH420/TR320/TR420/TF320/TF420
Compact Operating Instructions, 05/2020, A5E41865021-AC