Assembly And Set-Up - Razor A Series Owner's Manual

ASSEMBLY AND SET -UP
Attaching the Handlebars
(Select models)
1
Loosen the collar clamp and
slide it upward. Insert T-bar into
the fork until it bottoms out on the
headset locknut.
Note: If necessary, carefully twist
the T-bar side to side while pushing
downward until T-bar bottoms out
on the headset locknut.
Unfolding the Scooter for First Time Use
(Select models)
1
To release the folding mechanism,
place the scooter on the ground, put
one foot on the deck plate and push
joint release lever down. Raise T-bar
up until it is securely locked in the
upright position.
2
Insert and secure the left
and right handlebars by pressing
the spring-loaded buttons and
inserting them into the T-bar.
2
With the front wheel pointed
straight ahead and the
handlebars square to the front
wheel and the Razor logo facing
the front, tighten the clamp as
shown. Tighten securely. On the
A4, alternately tighten each bolt
until securely tightened.
Note: The joint release lever
is spring-loaded and will
automatically lock in the upright
position when fully upright.
3
Make certain BOTH handlebars
are properly locked onto the T-bar.
3
WARNING: Failure to
properly install and tighten the
collar clamp may cause the rider
to lose control and fall. If you are
having difficulty understanding
these instructions, please
contact Razor Customer Service
for assistance.
WARNING: Do not
attempt to thread the handle
bar into the front fork thread.
Tighten clamp securely.
WARNING:
Keep fingers clear of the pivoting
mechanism when folding or
unfolding the scooter. Make sure
others are standing clear.
WARNING: Failure to
properly engage the spring-loaded
buttons may cause the handlebars
to dislodge while riding and may
cause you to lose control and
fall. When correctly engaged the
handlebars will not rotate nor will
they move sideways. Note that
when properly engaged, the spring-
loaded buttons are clearly visible in
the holes on the T-bar.
WARNING: Check
hand grips and end caps regularly
for wear or damage, as they
are designed to aid in gripping
handlebars and to provide some
protection against possible impact.
Replace immediately if worn, torn,
damaged or missing.