Viper 5002 Owner's Manual page 46

p p r r o o g g r r a a m m m m i i n n g g
Programming options control what your system does during
normal operation, and require few or no additional parts.
However, some may require additional installation labor.
The following is a list of the program settings, with the factory
settings in B B o o l l d d : :
➤ A A c c t t i i v v e e a a r r m m i i n n g g (only with the remote) or passive arming (au-
tomatic arming 30-seconds after the last door has been
closed).
➤ Arming/disarming confirmation siren chirps o o n n or off.
➤ The ignition controlled door lock feature o o n n or off: With
this feature on, the doors will lock three seconds after the
ignition is turned on, and the doors are closed, and unlock
when the ignition is turned off. The system will not lock the
doors when the ignition is turned on with any door open.
The bitwriter is not needed to program theses separately, it
should be in the programming grid to do these 2 indepen-
dently. Ignition lock and unlock are independent features
and can be programmed separately.
➤ Passive door locking (with passive arming) or a a c c t t i i v v e e d d o o o o r r
l l o o c c k k i i n n g g (only when arming with the remote). Passive locking
allows the vehicle's doors to lock when the security system
passively arms (after the 30 second countdown). This feature
only works if passive arming has been programmed.
© 2006 directed electronics
41