Viper AS6690T Instructions For Use Manual page 26

INSTRUCTION FOR USE
Battery charging (The machine with off-board charger)
Connect the battery charger cable to the electrical mains (G, Figure 21)
6.
(the electrical mains voltage and frequency must be compatible with the
battery. When the battery charger is connected to the electrical mains, all
machine functions are automatically cut off).
When the battery charging is completed, disconnect the battery charger
7.
cable from the electrical mains (G)
Electrolyte levels should be checked after the batteries are charged.
8.
Insert the ignition key (42) and turn it to "I". Check the status of batteries
9.
on display screen (B, Figure 3)
10. Carefully lower the tank.
NOTE
If the machine is not equipped with on-board battery
charger, please choose an external battery charger
suitable for the type of batteries installed.
Battery charging (The machine with on-board charger)(*)
Change the battery connections (B, Figure 22) from (A) to (C.)
1.
Connect the battery charging cable (E) to (D) and connect the other end
2.
of the cable to the electrical outlet.
When the battery charging is completed, the green warning light on the charger turns on. Disconnect the battery charger cable (E)
3.
and Change the battery connections (B) from (C) to (A).
Electrolyte levels should be checked after the batteries are charged.
4.
Insert the ignition key (42, Figure 3) and turn it to "I". Check the status of batteries on display screen (B), Figure 3)
5.
Carefully lower the tank.
6.
E
D
C
Figure 22
24
G
Figure 21
B
A
ENGLISH